How to turn a standard definition TV into a HD TV
What you’ll need.
A Raspberry Pi 4 and a Raspberry Pi DVB TV Hat or a DVB-T/T2+C+FM+DAB dongle. You’ll also need a TV with HDMI input to plug the whole shooting match into.
The first thing to do is to get Raspbian installed and updated to the current standard. I didn’t pay any attention to secure passwords, etc. as this Pi is not going to be connected to the internet directly. Access is only going to be from the home network.
The next thing to do is to plug in either the Pi TV Hat
or your dongle.
Next step is to install TVHeadend – “sudo apt install tvheadend” will get the job done. Before you start on the next step a very important step is to plug the antenna into either your TV Hat or dongle.
Getting it configured
When you are installing TVHeadend be sure that you select a username and a password combination that’s dead easy to remember.
When you’ve got it installed break out your trusty web browser and go to https://x.x.x.x:9981. The x.x.x.x could be localhost if you are doing it from either a TV or monitor connected to the Pi or it could be another system connected to your home network. In either case you’ll be prompted to supply the username and password that you specified during the TVheadend installation. You’ll be presented with a configuration page which is easy to work through. There’s a wealth of info at tvheadend.org which will see you right.
At this stage you should have an Electronic Programme Guide (EPG) visible in your browser and now’s the time to test it to see if it all works. If at this point if you have no success go back to the TVheadend configuration. It took me a few iterations to get a handle on how it works. Once you can see the EPG you’re home and hosed.
Be aware though, you really do need a decent TV antenna to get it working. I don’t think the receivers in either the dongle or the Pi TV hat are very sensitive. Another problem that I ran into was getting the correct region to scan. I started out using “au-other” which was incorrect. When I used “au-Melbourne” it worked as advertised. Like all of my other issues, it was my faulty configuration.
Testing and Job Done
At this point yould be able to select a programme in your browser. You now may have problems getting your browser to support the stream from TVheadend. Don’t worry, salvation is at hand in the form of VLC which can play network streams.
Just install it on the system that uses your old, slow, standard definition TV. Open it up and go to “media -> Network Stream” and enter the followung “https://username:firstname.lastname@example.org:9981/playlist/channels.m3u” where “x.x.x.x” is the network address of the system that uses your TV as the display. Or any other system on your local home network. You may have to select “View -> Playlist” from the menu to get the playlist. From there you just select the channel that you want. Double click on it and hit full screen mode.
Be aware though, you’ll need a high speed network connection between the system with TVheadend and the system with the TV attached. Of course if the system with TVheadend is directly connected to the TV then this is redundant.
With this setup I can take my tablet down the back yard to the BBQ area and kick back with the cricket and a glass of wine or two. I can’t watch HD TV there though – I’m only just in range of my 2.4GHz wifi which doesn’t quite cut it but hey, it does the job.
Sit back with a glass of your favourite and watch the programme of your choice in HD whilst congratulating yourself on a job well done.